ENCORE FR20 DTW User Instructions
©2018 ADJ Products, LLC all rights reserved. Information, specifications, diagrams, images, and instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection claimed includes all forms and matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted.
Encore FR20 DTW Table of Contents Introduction 3 Features / Warranty Registration / Installation 4 Safety Precautions 5 Rear Overview / Operating Instructions 6 Barn Door Attachment 7 Frost Filter Attachment 8 Dimensional Drawing / Trouble Shooting / Cleaning 11 Warranty 12 Technical Specifications 13 ADJ Products, LLC - www.adj.
Encore FR20 DTW Introduction Unpacking: Thank you for purchasing the Encore FR20 DTW by ADJ Products, LLC. Every Encore FR20 DTW has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate the unit has arrived intact.
Encore FR20 DTW Features • Manual Dimming 0-100% INCLUDED: • Safety Cable • Frost Filter and Installation Kit (2 x Retainer Rings and Snoot Ring) • Barn Door • Gel Frame, Gel Frame Holder, and Spacer Encore FR20 DTW Warranty Registration The Encore FR20 DTW carries a 2 year limited warranty. Please fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight prepaid and accompany a return authorization (R.A.) number. The R.A.
Encore FR20 DTW Safety Precautions • To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture • Do not spill water or other liquids into or on to your unit. • Do not attempt to operate this unit if the power cord has been frayed or broken. Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to reduce the risk of electrical shock and fire in case of an internal short.
Encore FR20 DTW Rear Overview POWER CORD FUSE HOLDER MANUAL DIMMER KNOB Encore FR20 DTW Operating Instructions 1. Plug the fixture into a matching power source. 2. After plugging the fixture in, use the manual dimming knob located on the rear panel to adjust the output intensity. Turn the knob clockwise to raise the output intensity, or counter-clockwise to lower the output intensity and/or shut off the unit. 3.
Encore FR20 DTW Barn Door & Gel Frame Attachment BARN DOOR ONLY GEL FRAME WITH BARN DOOR 1. Open lock and slide the provided spacer (not shown) in from the top and into the 1st and 2nd slots (see inset view below). 1. Open lock and slide the Gel Frame in from the top and into the slot located closest to the unit (Slot 2). Lock Open Lock Open 2. Slide the Barn Door in from the top, in front of the Gel Frame. The Barn Door will sit in the same slot as the Gel Frame (Slot 2).
Encore FR20 DTW Frost Filter Attachment Frost Filter 1. Carefully place the FROST FILTER lens on top of the LED lens, making sure it fits securely in place. Inner Retainer Ring Groove Inner Retainer Ring 2. Carefully insert the INNER RETAINER RING into the inner most groove, making sure it rests securely inside the inner groove. Make sure there is no space between the INNER RETAINER RING and the FROST FILTER lens. ADJ Products, LLC - www.adj.
Encore FR20 DTW Frost Filter Attachment Snoot Ring 3. Carefully insert the SNOOT RING on top of the FROST FILTER, making sure it sits flush against the FROST FILTER. Outer Retainer Ring Groove Outer Retainer Ring 4. Carefully insert the OUTER RETAINER RING into the outer most groove, making sure it rests securely inside the outer groove. ADJ Products, LLC - www.adj.
Encore FR20 DTW Frost Filter Attachment COMPLETE RETAINER RING 2 SNOOT RING RETAINER RING 1 FROST FILTER ADJ Products, LLC - www.adj.
Dimensional Drawings 160.89mm / 6.33” Encore FR20 DTW 269.21mm / 10.6” 133mm / 5.24” 116mm / 4.57” 209.85mm / 8.26” 185mm / 7.28” 93.21mm / 3.67” 83.6mm / 3.29” Encore FR20 DTW Trouble Shooting Listed below are a few common problems the user may encounter, with solutions. No Light Output: 1. Check that the unit is plugged into a working power source. 2. Check the manual dimming knob setting.
Encore FR20 DTW Warranty MANUFACTURER’S LIMITED WARRANTY A. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products to be free of manufacturing defects in material and workmanship for a prescribed period from the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories.
Encore FR20 DTW Specifications Model: Encore FR20 DTW Voltage: 100V ~ 240V/50~60Hz LEDs: 1 x 17W LED Color Temperature: 3000k Working Position: Any safe working position Power Draw: 17W Fuse: 1Amp Weight: 5 lbs./ 2.25 Kgs. (w/ Barn Door) 4.3 lbs./ 1.95 Kgs. (w/o Barn Door) Dimensions: With Barn Doors: 10.6” (L) x 6.33” (W) x 8.26” (H) 269.21 x 160.89 x 209.85mm Without Barn Doors: 7.28” (L) x 6.33” (W) x 8.26” (H) 185 x 160.89 x 209.
