Encore Profile 1000 Color ADJ Products, LLC 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-2650 / Fax: 323-725-6100 Web: www.adj.com / E-mail: info@americandj.com A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade The Netherlands service@adjgroup.eu / www.adj.
©2016 ADJ Products, LLC all rights reserved. Information, specifications, diagrams, images, and instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection claimed includes all forms and matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted.
Encore Profile 1000 Color Notes Encore Profile 1000 Color Introduction Unpacking: Thank you for purchasing the Encore Profile 1000 Color by ADJ Products, LLC. Every Encore Profile 1000 Color has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping.
Encore Profile 1000 Color Features Encore Profile 1000 Color Notes • • • • • • • • Five Operating Modes Electronic Dimming 0-100% 5 Selectable Dimming Curves 64 Color Macros 4 Included Gobos DMX-512 protocol 3-Pin & 5-Pin DMX Connections 5 DMX Modes: 4 Channel Mode, 5 Channel Mode, 6 Channel Mode, 10 Channel Mode, & 11 Channel Mode.
Encore Profile 1000 Color Warranty MANUFACTURER’S LIMITED WARRANTY A. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products to be free of manufacturing defects in material and workmanship for a prescribed period from the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories.
Encore Profile 1000 Color DMX Set Up Power Supply: The ADJ Encore Profile 1000 Color contains a auto- matic voltage switch, which will auto sense the voltage when it is plugged into the power source. With this switch there is no need to worry about the correct power voltage, this unit can be plugged in anywhere. DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of communication between intelligent fixtures and controllers.
Encore Profile 1000 Color Gobo Install Encore Profile 1000 Color DMX Set Up POWER The Encore Profile 1000 Color comes with 4 replaceable gobos (see below). To install a gobo, unscrew and remove the phillips screw located at the bottom of the gobo holder. Gently lift part of the gobo holder side up and carefully slide the gobo into place. Reinstall the phillips and screw and tighten. Slide the gobo holder into the slot located at the top of the unit in front of the framing lever.
Encore Profile 1000 Color Operating Instructions Encore Profile 1000 Color Photometric Chart Encore Profile 1000 Color CAD Drawing LCD Backlight On/Off: To set the LCD backlight to turn off after 20 seconds, press the MODE button until “OTHER” is displayed, press the SET UP button until “OTHER BLGT:XX” is displayed. “XX” represents the current state. Press the UP or DOWN buttons to set the backlight to turn “OFF” after 20 seconds or “ON” to stay on at all times.
0 0 255 0 255 253-255 255 255 255 Color32 125-128 255 138 138 Color31 121-124 169 255 Color64 0 100 99 Color30 117-120 0 255 Color63 249-252 255 189 0 165 138 151 Color29 113-116 138 255 Color62 245-248 0 247 0 107 147 255 Color28 109-112 147 251 Color61 241-244 198 231 0 8 138 255 Color27 105-108 138 186 Color60 237-240 156 222 0 0 147 255 Color26 101-104 175 147 Color59 233-236 107 35 0 153 255 Color25 97-100 251 153 Color58 42 46 85 0 229-2
Encore Profile 1000 Color 3. Operating Instructions color you can activate strobing by pressing the SET UP button to enter the strobe mode. “STROB:XX” will be displayed, this is strobe mode. The strobing can be adjusted between “00” (flash off) to “15” (fastest flash). DMX Mode: Operating through a DMX controller gives the user the freedom to create their own programs tailored to their own individual needs.
Encore Profile 1000 Color Channel Value 8 10 Function COLOR MACROS/PROGRAMS/ AUTO RUN 192 - 207 208 - 223 224 - 239 240 - 255 9 11 Channel Mode 0 - 15 16 - 31 32 - 47 48 - 63 64 - 79 80 - 95 96 - 111 112 - 127 128 - 143 144 - 159 160 - 175 176 - 191 192 - 207 208 - 223 224 - 239 240 - 255 0 - 255 0 - 28 29 - 57 58 - 86 87 - 114 115 - 142 143 - 170 171 - 198 199 - 226 227 - 255 COLOR CHANGE PROGRAMS COLOR CHANGE 13 COLOR CHANGE 14 COLOR CHANGE 15 COLOR CHANGE 16 COLOR FADE PROGRAMS COLOR FADE 1 C
Encore Profile 1000 Color Operating Instructions functions. To control the Encore Profile 1000 Color, plug the included IR receiver into IR receiver input located on the rear of the controller. You must aim the remote at the IR sensor and be no more the 30 feet away. 1. Plug the fixture in and press the MODE button until “OTHER MODE” is displayed. 2. Press the SET UP button until “IR: XX” is displayed. 3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
Encore Profile 1000 Color Channel Value 8 10 Function COLOR MACROS/PROGRAMS/ AUTO RUN 192 - 207 208 - 223 224 - 239 240 - 255 9 10 Channel Mode 0 - 15 16 - 31 32 - 47 48 - 63 64 - 79 80 - 95 96 - 111 112 - 127 128 - 143 144 - 159 160 - 175 176 - 191 192 - 207 208 - 223 224 - 239 240 - 255 0 - 255 0 - 20 21 - 40 41 - 60 61 - 80 81 - 100 101 - 255 COLOR CHANGE PROGRAMS COLOR CHANGE 13 COLOR CHANGE 14 COLOR CHANGE 15 COLOR CHANGE 16 COLOR FADE PROGRAMS COLOR FADE 1 COLOR FADE 2 COLOR FADE 3 COLOR F
Encore Profile 1000 Color ADJ LED RC2 Operation The ADJ LED RC2 infrared remote (sold seperately) has many differnet functions to control your Encore Profile 1000 Color. To control the fixture you must aim the controller at the infrared sensor and be no more the 30 feet away. To use the ADJ LED RC2 you must first activate the fixtures infrared sensor, to activate the sensor please see the instructions on pages 10-11. Blackout - Pressing this button will blackout the fixture.
Encore Profile 1000 Color Channel 1 2 3 4 5 6 Value 0 - 255 0 - 255 0 - 255 0 - 255 0 - 255 0 - 15 16 - 255 6 Channel Mode Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% WHITE 0% - 100% MASTER DIMMER 0% - 100% SHUTTER/STROBE LED OFF STROBING SLOW - FAST Encore Profile 1000 Color ADJ LED RC2 Operation R G B W - Press either one of these buttons and the press the “+” or “-” to adjust the brightness. Press the FLASH button to activate strobing and use the “+” or “-” to adjust the flash speed.
Encore Profile 1000 Color UC IR Remote & Airstream IR The UC IR (sold separately) infrared remote gives you control of various functions (See below). To control the fixture you must aim the remote at the front of the fixture and be no more than 30 feet away. The Airstream IR (sold separately) remote transmitter plugs into the headphone jack of your iOS phone or tablet.
