Instruction manual

FREQ Matrix Quad System Menu
ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 7 ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 8
FREQ Matrix Quad System Menu
ADDR - DMX Address Setting via control board -
1. Press the MENU button until “ADDR” is displayed, press
ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to nd your desired address.
3. Press ENTER to conrm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least
3 seconds.
CHND - This will let select your desired DMX channel
mode.
1. Press the either the MENU button until “CHND” is displayed,
press ENTER. Either “2CH”, “5CH”, “18CH” or “64CH” will be
displayed
2. Press the UP or DOWN buttons to nd your desired DMX
channel mode and press ENTER to conm and exit.
SLND - This will let you set unit as a master or slave in a
master/slave conguration.
1. Press the MENU button until “SLND” is displayed, press
ENTER. Either “SL 1” or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to conm.
NOTE: In a Master/Slave conguration you can set one xture
to Slave 1 (SL 1) and then set the next xture to Slave 2 (SL 2),
in doing this the xtures will now have contrast movement to
each other.
SHND: SH 0 - SH 8 - Show modes 0 - 8