Instruction manual

ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 9 ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 10
FREQ Matrix Quad System Menu
1. Press the MENU button until “SHND” is displayed, press
ENTER.
2. “SH X” will now be displayed. “X” representing a number
between 0-8. Shows 1-8 are preset shows, while “SH 0” is random
show. Press the UP or DOWN buttons to nd your desired show.
3. Once you have found your desired show press ENTER, and
then press and hold the MENU button for at least 3 seconds to
conrm.
SOUN - In this submenu you can activate sound active
mode.
1. Press the MENU button until “SOUN” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
conrm.
SENS - Sound sensitivity control.
1. Press the MENU button until “SENS” is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sensi-
tive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button for at
least 3 seconds to conrm.
DNST - This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the xture will go into when
the DMX signal is lost. You can also set this as the operat-
FREQ Matrix Quad System Menu
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “DNST” is displayed, press
ENTER.
2. Either “MASL”, “BLND”, or “LAST” will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
• MASL (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the xture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to conrm your desired set up.
LED - With this function the LED display will turn off after
2 minutes.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn off after 2 min-
utes. Press any button to turn the LED display on again.
3. Press ENTER to conrm your selection.
DISP - This will “ip” the LED display
1. Press the MENU button until “DISP” is displayed, press
ENTER.
2. When “DISP” is displayed the LED display will remain normal,