User manual

©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 19 ©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 20
Inno Color Beam LED Fuse Replacement
Inno Color Beam LED Cleaning
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact American DJ® for service.
1-800-322-6337
Inno Color Beam LED Troubleshooting
Locate and remove the unit’s power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry out
the fuse holder. Remove the bad fuse and replace with a new one. The
fuse holder has a built-in socket for a spare fuse be sure not to confuse
the spare fuse with active fuse.
Inno Color Beam LED UC3 Control
Inno Color Beam LED Power Cord Daisy Chaining
With this feature you can connect the xtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 4 xtures maximum. After 4 xtures you will need to
use a new power outlet. They must be the same xtures. DO NOT
mix xtures.
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Show
1-4
1. Pan position
2. Tilt position
3. Dimmer
Fade Speed
1. Fast
2. Middle
3. Slow
Mode Sound
(LED OFF)
Show
(LED ON)
Show
(LED Fast Blinking)
(LED Slow
Blinking)
Inno Color Beam LED Photometric Chart