User manual

Inno Color Beam LED System Menu Inno Color Beam LED System Menu
2. “MODE X” will be displayed, “X” representing the displayed
dimmer mode. The modes are explained below.
Dimmer Mode 1 (Linear) - Steady, even increase in dimming.
Dimmer Mode 2 (Square Law) - Provides ner dimming control
near full intensity.
Dimmer Mode 3 (Inverse Square Law) - Provides ner dimming
control at lower intensities.
Dimmer Mode 4 (S-Curve) - Similar to Linear dimming with ner
dimming control at mid level intensities.
3. Press the UP or DOWN buttons to nd your desired show
mode and press ENTER, then press and hold the MENU button
for at least 3 seconds to conrm.
Slave Mode - This will let you set unit as a master or
slave in a master/slave conguration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Slave 1” or “Slave 2” will be displayed.
2. Press the UP or DOWN buttons until your desired slave mode
is displayed, press ENTER to conm.
NOTE: In a Master/Slave conguration you can make one x-
ture the Master and then set the next xture to “Slave 2”, the
xtures will now have contrast movement to each other.
Black Out - This will control blackout
1. Press the MENU button until “Black Out” is displayed, press
ENTER.
2. Either “Yes” or “No” will now be displayed. Press the UP or
DOWN buttons to toggle between “Yes” and “No”.
3. Press ENTER to conrm your setting.
Sound State - In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “O” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “O”.
3. Press ENTER to conrm your selection, the press and hold the
MENU button to activate.
Sound Sense - In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Inverse - Pan Inversion
1. Press the MENU button until “Pan Inverse” is displayed,
press ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to conm. To deactivate
Pan inversion, select “No” and press Enter.
Tilt Inverse - Tilt Inversion
1. Press the MENU button until “Tilt Inverse” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 9 ©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 10