User manual

©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 12©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 11
until “Yes” is displayed, press ENTER to conm. To deactivate
Tilt inversion, select “No” and press Enter.
Back Light - With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the backlight on at all
times, or “OFF” to allow the backlight to turn o after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to conrm.
Function Delay - With this function the DMX address
setting will be delayed by the amount of time chosen.
1. Press the MENU button until “Function Delay” is displayed,
press ENTER.
2. Either “No Delay” or time between 1s - 3s will be displayed.
This number represents the delay setting. Use the UP and DOWN
buttons to adjust the DMX address delay.
3. Press ENTER to conrm.
White Balance - With this function you can adjust the
RGB colors to make your desired color.
1. Press the MENU button until “White Balance” is displayed,
press ENTER.
2. Use the UP or DOWN buttons to nd the color you wish to
adjust.
3. Once you nd the color you want to adjust press ENTER, the
displayed value will begin to ash. Use the UP or DOWN but-
tons to adjust the value. Once you have made your adjustment
press ENTER.
4. Repeat steps 2-3 until satised.
Dimmer Calibrat - With this function you can set the
output intensity.
1. Press the MENU button until “Dimmer Calibrat” is displayed,
press ENTER.
2. A number between 50-100 will be displayed. This number rep-
resents the instensity setting. Use the UP or DOWN buttons to
adjust the LED output intensity. 50 being medium intensity, and
100 being full intensity.
3. When you have found your desired setting press ENTER to
conrm.
Manual Test - With this function you can manually test
the individual features.
1. Press the MENU button until “Manual Test” is displayed,
press ENTER.
2. Use the UP or DOWN buttons to nd the functions or colors
that you wish to test. You can also test the strobe function and
dimmer.
3. Once you nd a function or color you wish to test, press the
ENTER button, the displayed value will begin to ash. You can
now adjust the values by pressing the UP and DOWN buttons.
Once you have nished testing press the ENTER button.
4. To exit the manual test mode, press the MENU button.
Auto Test - This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, press
Inno Color Beam LED System Menu Inno Color Beam LED System Menu