User manual

©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 14©American DJ Supply® - www.americandj.com - Inno Color Beam LED User Manual Page 13
ENTER.
2. The xture will now run a self test. Press the MENU button to
exit.
Temp. - With this function you can display the running
temperature of the unit.
1. Tap the MENU button until “Temp.” is displayed, press
ENTER.
2. The current running temperature of the xture will now be dis-
played. Press MENU to exit.
Fixture Time - With this function you can display the
running time of the unit.
1. Tap the MENU button until “Fixture Time” is displayed, press
ENTER.
2. The running time of the xture will now be displayed. Press
MENU to exit.
Firmware Version - This will display the software ver-
sion
1. Tap the MENU button until “Firmware Version” is displayed.
Press the ENTER button and the software vesion will be dis-
played.
2. Press the MENU button to leave this function.
Default - Choose between PRO Default or AUTO Default.
1. Tap the MENU button until “DEFAULT” is displayed, press
ENTER.
2. Either “YES” or “NO” will now be displayed. Press the UP or
Inno Color Beam LED System Menu Inno Color Beam LED System Menu
DOWN buttons to select “YES” to switch back to defualt set-
tings, and press ENTER.
3. Either “PRO Defaults” or “AUTO Defaults” will be displayed.
Use the UP or DOWN buttons to switch between the two default
modes. Press ENTER to make your selection. The default details
are below.
PRO -
Slave Mode: Slave 1
Black Out: Yes
Sound State: O
Pan Inverse: No
Tilt Inverse: No
Back Light: O
Function Delay: 3S Delay
AUTO -
Slave Mode: Slave 1
Black Out: No
Sound State: On
Pan Inverse: No
Tilt Inverse: No
Back Light: On
Function Delay: 3S Delay
Reset - Use this function to reset the unit.
1. Tap the MENU button until “RSET” is displayed, press ENTER.
2. The xture will now reset.