Instruction manual

American DJ® - www.americandj.com - Inno Roll LED Instruction Manual Page 2
Inno Roll LED General Information
Unpacking: Thank you for purchasing the Inno Roll LED by Ameri-
can DJ®. Every Inno Roll LED has been thoroughly tested and has
been shipped in perfect operating condition. Carefully check the ship-
ping carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your xture for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return this unit to your dealer without con-
tacting customer support rst.
Introduction: The Inno Roll LED is a 8 channel DMX intelligent LED
scanner. The Inno Roll LED has three operating modes; a sound active,
show mode, DMX controlled. The Inno Roll LED can operate as a stand
alone fixture or in a Master/Slave configuration. For best results use
fog or special effects smoke to enhance the beams projections.
Customer Support: American DJ® provides a toll free customer
support line, to provide help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 8:00 a.m. to
4:30 p.m. Pacic Standard Time.
Voice: [phone]
Fax: [phone]
E-mail: [e-mail]
To purchase parts online visit http://parts.americandj.com
Warning! To prevent or reduce the risk of electrical shock or re, do
not expose this unit to rain or moisture.
Warning! This may cause severe eye damage. Avoid looking directly
into the light source at all times!
User Instructions
Rev. 6/12