User manual

ManualsBrandsADJ ManualsLightingMega GO Bar 50 RGBA

©American DJ® - www.Americandj.com - Mega GO Bar 50 User Manual Page 23

Mega GO Bar 50 Trouble Shooting

Listed below are a few common problems the user may encounter,

with solutions.

Unit not responding to DMX:

1. Check that the DMX cables are connected properly and are

wired correctly (pin 3 is “hot”; on some other DMX devices

pin 2 may be ‘hot’). Also, check that all cables are connected

to the right connectors; it does matter which way the inputs

and outputs are connected.

Unit does not respond to sound:

1. Quiet or high pitched sounds will not activate the unit.

2. Make sure that Sound Active mode is activated.

Mega GO Bar 50 Cleaning

Due to fog residue, smoke, and dust cleaning the internal and exter-

nal optical lenses must be carried out periodically to optimize light

output.

1. Use normal glass cleaner and a soft cloth to wipe down the

outside casing.

2. Clean the external optics with glass cleaner and a soft cloth

every 20 days.

3. Always be sure to dry all parts completely before plugging

the unit back in.

Cleaning frequency depends on the environment in which the fixture

operates (i.e. smoke, fog residue, dust, dew).

Disconnect the unit from its power source. Remove the power cord

from the unit. Once the cord has been removed, you will find that the

fuse holder is located inside the power socket. Insert a flat-head screw

driver into the power socket and gently pry out the fuse holder. Remove

the bad fuse and replace with a new one. The fuse holder also has a

holder for a spare fuse.

Mega GO Bar 50 Fuse Replacement

With this feature you can connect the xtures to one another

using the IEC input and output sockets. The quantity that can be

connected is 25 xtures maximum. After 25 xtures you will need

to use a new power outlet. They must be the same xtures. DO

NOT mix xtures.

Mega GO Bar 50 Power Cord Daisy Chain Mega GO Bar 50 Battery Status & Charging

Battery Status:

This function is used to check the life status of the battery.

Plug the fixture in and press the MODE button until “bXXX” is

displayed. “XXX” represents an number between “000” and

“100”. The number that is displayed is the remaining battery

life. If “b---” is displayed, it means the battery is dead or you are

running the unit on AC power. Please do not let the battery

fully die, this severly shortens the life of the battery.

Example: If “b050” is displayed, the battery is at half life. If

“b025” is displayed, the battery is at 25% life.

NOTE: When the battery is charging or if the battery life is

below 30% the digital display will flicker.

Battery Recharge: To recharge the battery, plug the supplied AC

cord into the AC input on the side of the unit and plug the other

end into a matching power supply. It takes about 6.5 hours to

reach full charge.

For a faster recharge, put the Load Switch in the “Off” position

and the Battery Switch in the “ON” position.