MEGA TRIPAR PROFILE PLUS ADJ Products, LLC 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-2650 / Fax: 323-725-2941 Web: www.adj.com / E-mail: info@americandj.com A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade Netherlands support@adjgroup.eu / www.adj.
©2015 ADJ Products, LLC all rights reserved. Information, specifications, diagrams, images, and instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection claimed includes all forms and matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted.
Mega TRIPAR Profile Plus Notes Mega TRIPAR Profile Plus Introduction Unpacking: Thank you for purchasing the Mega TRIPAR Profile Plus by ADJ Products, LLC. Every Mega TRIPAR Profile Plus has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping.
Mega TRIPAR Profile Plus Features • • • • • • • • Five Operating Modes Electronic Dimming 0-100% 5 Selectable Dimming Curves 64 Color Macros Built in Microphone DMX-512 protocol 3-Pin DMX Connection 5 DMX Modes: 4 Channel Mode, 5 Channel Mode, 6 Channel Mode, 9 Channel Mode, & 10 Channel Mode. • ADJ LED RC2 compatiable (Not Included) • Power Cord Daisy Chain (See page 27) Mega TRIPAR Profile Plus Warranty Registration The Mega TRIPAR Profile Plus carries a 2 year limited warranty.
Mega TRIPAR Profile Plus Power Cord Daisy Chain With this feature you can connect the fixtures to one another using the IEC input and output sockets. The quantity that can be connected is 30 fixtures maximum. After 30 fixtures you will need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures. Mega TRIPAR Profile Plus Fuse Replacement Disconnect the unit from its power source. Remove the power cord from the unit.
Mega TRIPAR Profile Plus Safety Precautions Mega TRIPAR Profile Plus Photometric Chart Mega TRIPAR Profile Plus Dimmer Curve Chart RISK GROUP 3 - RISK OF EXPOSURE TO ULTRAVIOLET (UV) RADIATION! FIXTURE EMITS HIGH INTENSITY ULTRAVIOLET (UV) LIGHT AT A WAVELENGTH OF 401NM - 438NM. WEAR PROPER EYE AND SKIN PROTECTION. AVOID PROLONGED PERIODS OF EXPOSURE. AVOID WEARING WHITE COLOR CLOTHING AND/OR USING (UV) PAINTS ON SKIN. AVOID DIRECT EYE AND/OR SKIN EXPOSURE AT DISTANCES SHORTER THAN 11 feet (3.3m).
0 255 0 0 0 253-255 0 255 255 125-128 Color32 255 255 138 255 121-124 Color31 138 169 138 117-120 Color30 151 138 255 Color64 255 0 0 249-252 0 138 113-116 Color29 151 138 255 Color63 247 198 165 245-248 0 147 109-112 Color28 255 147 251 Color62 231 156 107 241-244 0 105-108 Color27 255 138 138 Color61 222 107 8 237-240 0 186 Color60 35 46 0 233-236 147 101-104 Color26 255 175 147 Color59 0 182 85 165 219 209 42 229-232 153 225-228 Color57 144 153 251 Color25
Mega TRIPAR Profile Plus DMX Set Up POWER POWER Notice: Be sure to DMX512 follow figures two and three when making your own cables. Do not use the ground lug on the XLR connector. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behavior.
Mega TRIPAR Profile Plus Channel Value 8 10 Channel Mode Function COLOR MACROS/PROGRAMS/ SOUND ACTIVITIY 48 - 63 64 - 79 80 - 95 96 - 111 112 - 127 128 - 143 144 - 159 160 - 175 176 - 191 192 - 207 208 - 223 224 - 239 240 - 255 COLOR CHANGE PROGRAMS COLOR CHANGE 4 COLOR CHANGE 5 COLOR CHANGE 6 COLOR CHANGE 7 COLOR CHANGE 8 COLOR CHANGE 9 COLOR CHANGE 10 COLOR CHANGE 11 COLOR CHANGE 12 COLOR CHANGE 13 COLOR CHANGE 14 COLOR CHANGE 15 COLOR CHANGE 16 0 - 15 16 - 31 32 - 47 48 - 63 64 - 79 80 - 95 96
Mega TRIPAR Profile Plus 3. 4. 5. 6. 7. Operating Instructions access green dimming. When “G.XXX” is displayed you are in Green dimming mode. Press the UP and DOWN buttons to adjust intensity. When “b.XXX” is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to adjust intensity. When “u.XXX” is displayed you are in UV dimming mode. Press the UP and DOWN buttons to adjust intensity.
Mega TRIPAR Profile Plus Channel Value 8 9 9 Channel Mode Function COLOR MACROS/PROGRAMS/ SOUND ACTIVITY 0 - 15 16 - 31 32 - 47 48 - 63 64 - 79 80 - 95 96 - 111 112 - 127 128 - 143 144 - 159 160 - 175 176 - 191 192 - 207 208 - 223 224 - 239 240 - 255 0 - 255 0 - 255 SOUND ACTIVE PROGRAMS SOUND ACTIVE MODE 1 SOUND ACTIVE MODE 2 SOUND ACTIVE MODE 3 SOUND ACTIVE MODE 4 SOUND ACTIVE MODE 5 SOUND ACTIVE MODE 6 SOUND ACTIVE MODE 7 SOUND ACTIVE MODE 8 SOUND ACTIVE MODE 9 SOUND ACTIVE MODE 10 SOUND ACTIVE
Mega TRIPAR Profile Plus Operating Instructions • To run the 9 Channel Mode, press the MODE button until “Ch09” is displayed. This is the 9 Channel DMX Mode. • To run the 10 Channel Mode, press the MODE button until “Ch10” is displayed. This is the 10 Channel DMX Mode. 4. Please see pages 17-24 for DMX values and traits. 5. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections to any standard DMX controller. Default Running Mode: This is a default running mode.
Mega TRIPAR Profile Plus Channel 1 2 3 4 5 6 7 8 Value 0 - 255 0 - 255 0 - 255 0 - 255 0 - 31 32 - 63 64 - 95 96 - 127 128 - 159 160 - 191 192 - 223 224 - 255 0 - 255 0 - 51 52 - 102 103 - 153 154 - 204 205 - 255 0 - 255 0 - 15 16 - 31 32 - 47 9 Channel Mode Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% UV 0% - 100% SHUTTER/STROBE LED OFF LED ON STROBING SLOW - FAST LED ON STROBE PULSE SLOW - FAST LED ON RANDOM STROBE SLOW - FAST LED ON MASTER DIMMER 0% - 100% PROGRAM SELECTION MODE DIMM
Mega TRIPAR Profile Plus Master-Slave Configuration Master-Slave Configuration: This function will allows you to link units together to run in a MasterSlave set-up. In a Master-Slave set-up one unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to act as the “Master.” Master-Slave Connections and Settings: 1.
Mega TRIPAR Profile Plus Channel 1 2 3 4 Value 0 - 255 0 - 255 0 - 255 0 - 255 Mega TRIPAR Profile Plus Channel 1 2 3 4 5 Value 0 - 255 0 - 255 0 - 255 0 - 255 0 - 255 4 Channel Mode Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% UV 0% - 100% 5 Channel Mode Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% UV 0% - 100% MASTER DIMMER 0% - 100% Mega TRIPAR Profile Plus ADJ LED RC2 Operation The ADJ LED RC2 infrared remote (sold seperately) has many differnet functions and gives y
Mega TRIPAR Profile Plus ADJ LED RC2 Operation SET ADDRESS - Press this button to set the DMX address. Press this button first, then press the numbers to set the address. Example: Set DMX Address 1 Press “0-0-1” Set DMX Address 245 Press “2-4-5” Mega TRIPAR Profile Plus ADJ LED RC2 Operation Channels. • If the UV LED flashes you are in DMX Mode 5: 10 DMX Channels. R G B A - Press either one of these buttons and the press the “+” or “-” to adjust the brightness. “A” selects UV dimmer mode.
