User manual

INTERNAl MENU
©American Audio® - www.americanaudio.com - UCD-100 MKII Instruction Manual Page 23
Hold TIME BUTTON for 3 seconds to enter the internal menu. Turn TRACK KNOB to scroll through the dier-
ent menus and press the TRACK KNOB to enter the corresponding submenu. Turn TRACK KNOB to change
the submenus and press TIME BUTTON to memorize your settings in any operating mode and exit the menu.
1. Playlist – Normal / Title/ Artist / Album/ Genre
Normally the unit will read your USB devices in order of folder name and le names in folders. Title, Artist,
Album and Genre will use your last built database le when scrolling through the selected database in alpha-
betical order. When new les are added it is necessary to build a new database for the MP3 les to read in
any mode described.
2. Sleep Time – No sleep, 5~120 min
Set the time the player takes to enter sleep mode. When in sleep mode, the player will either read sleep or
ZZZZZ on the LCD screen.
3. Line Setup – MODE= 1~3(Line mode)
Dis=0.5~12.0 sec. (LINE NAME start/stop time adjustment)
Run=50~2000 msec. (LINE NAME move time adjustment)
4. Bit rate – Display ON/OFF
Display the bit rate o MP3 les.
5. Rec. USB - Select the recording device between USB1 & USB2. (The default setting is USB1)
6. Rec. Bitrate - Select the Rec. Bitrate between 32000,40000,48000,56000,64000,80000,96000,112000,
128000(Defaults),160000,192000,224000,256000,320000.
7. Version – CON:XX (Control version)
DSP:XX (DSP version)
SER:XX (Servo version)
Displays the rmware version.
8. Load Default – Press TRACK Knob to enter load defaults. (LCD displays “Load OK”.)
Will reset all settings to factory default except for Firmware version.
9. Exit & Save – Exit & Save setting to next power on (LCD displays “Saving”.)
This will save all changes if changes are not saved the unit will revert to last saved changes on power o.
Press the TRACK knob to fast exit & save in any operating mode.
NOTE:
SLEEP TIME: The CD player automatically shuts o the transport and laser after about 15 minutes when in
pause or cue mode). This extends the life of your motor drive and laser. During sleep mode the display
shows the word “SLEEP”. To wake up the player, just press the cue or play button, the display turns to
normal and is ready to receive instructions. You can enter the Sleep Time menu to adjust sleep time, range
is 5~120 minutes.
SAVE: PITCH ON/OFF, PITCH RANGE, SGL/CTN, AUTO CUE, TIME MODE, KEY LOCK, DISPLAY/SCROLL,
TIME/JOG MODE.
DEFAULTS: PITCH (ON), PITCH RANGE (8%), PLAY MODE(CTN), AUTO CUE(ON), TIME MODE
(REMAIN), KEY LOCK(OFF), BIT RATE(Disp. ON), REPEAT MODE (OFF), PLAYLIST
(NORMAL), SLEEP TIME (15 min), LINE SETUP(model 1), DISPLAY(1 sec),RUN TIME(150msec)