Instructions / Assembly

Adaptation Instructions for The Grate Escape
The Grate Escape Security Kit has been engineered to specifically attach to the
Adjust-A-Grates. The following are our best recommendations if you need to modify
how the security kit attaches to a different style of grate.
EXPANDED
METAL GRATE
Purchase two ” fender washers, available at any home ⅜
improvement or hardware store, ensuring the included bolts will
fit flush with the top of the washers. You will then remove and
discard the top clip, keeping the provided bolts and nuts. Run
the bolts down through the fender washers, then through the
holes on your grate and into the bottom clip of the security kit.
Use included nuts to attach this bottom clip on the underside of
your grate. It is necessary to keep the cable of the security kit
as close to the center of your grate as possible. Proceed with
remaining installation instructions.
Purchase a ¼” x 1” x 1 ¾” U-Bolt, available at any home
improvement or hardware store. The last dimension on the U-
Bolt is for the height so one a little longer could be necessary
depending on the thickness of your grate. Replace the top clip
and the included bolts from the security kit with the U-Bolt. Place
the U-Bolt over a central bar or support in the grate (the U-Bolt
may have to be spread slightly) then through the holes on the
bottom clip of the security kit on the underside of your grate. It is
necessary to keep the cable of the security kit as close to the
center of your grate as possible. Proceed with remaining
installation instructions.
BAR GRATE
Adaptation Instructions for The Grate Escape
The Grate Escape Security Kit has been engineered to specifically attach to the
Adjust-A-Grates. The following are our best recommendations if you need to modify
how the security kit attaches to a different style of grate.
EXPANDED
METAL GRATE
Purchase two ” fender washers, available at any home ⅜
improvement or hardware store, ensuring the included bolts will
fit flush with the top of the washers. You will then remove and
discard the top clip, keeping the provided bolts and nuts. Run
the bolts down through the fender washers, then through the
holes on your grate and into the bottom clip of the security kit.
Use included nuts to attach this bottom clip on the underside of
your grate. It is necessary to keep the cable of the security kit
as close to the center of your grate as possible. Proceed with
remaining installation instructions.
Purchase a ¼” x 1” x 1 ¾” U-Bolt, available at any home
improvement or hardware store. The last dimension on the U-
Bolt is for the height so one a little longer could be necessary
depending on the thickness of your grate. Replace the top clip
and the included bolts from the security kit with the U-Bolt. Place
the U-Bolt over a central bar or support in the grate (the U-Bolt
may have to be spread slightly) then through the holes on the
bottom clip of the security kit on the underside of your grate. It is
necessary to keep the cable of the security kit as close to the
center of your grate as possible. Proceed with remaining
installation instructions.
BAR GRATE