Operating instructions

CAUTION !
The functions set with the keys only valid for the sewing program
in
the series mode
.
The settings have no effect on the sewing programm beyond the
series mode.
–
745-24
: Each entry of a sewing length must be confirmed with the
"Σ" key.
–
745-24
: Programming the light barrier seam
LX1, LX2
or
LX3
:
Press the " " key until the desired light barrier seam
X1, X2
or
X3
appears in the display.
Set the desired functions for the selected sewing lenght using the
keys listed on page 9.
Confirm with the "Σ" key.
–
After selecting a sewing length (L1, L2 or L3) stacking after this
sewing length can be programmed by pressing the "
+
" key.
CAUTION !
With the
745-24
the selection of the sewing length and the functions
must first be confirmed with the "Σ" key.
Then stacking after this sewing length can be programmed by pressing
the "
+
" key.
–
By pressing the "
-
" key the last entry is erased.
–
To start the series press the key "
F
" again.
The first sewing length is automatically set.
3.3 Setting the Piece Counter
By pressing this key the piece counter is reset to
0000
.
The current piece count is shown in the left half of the lower display
line. The piece counter shows the number of pieces made since the
last resetting of the counter.
3.4 Selecting the Positioning Point
Depending on the type of sewing pieces the feed occurs at the forward
or rear positioning point.
By pressing this key the positioning point is changed.
If the LED above the key is lit then the forward positioning point was
selected.
The changeover between manual and automatic alteration of the
positioning points occurs in program P42.
3.5 Switching the Tape Feed On/Off
By pressing this key the tape feed is switched on and off.
If the LED above this key is lit then the tape feed is switched on.
10