Operating instructions

Display example: Straight pocket corners
BL
= Beginning-left needle
BR
= Beginning-right needle
ER
= End-right needle
EL
= End-left needle
Selected sewing distance
Programming the bias of the pocket corners:
–
Simultaneously press the key for the desired sewing distance (
L1
,
L2
or
L3
) and the " " key.
–
For selecting a light barrier seam:
Press the " " key until the desired light barrier seam
LX1
,
LX2
or
LX3
appears in the display.
Simultaneously press the " " and the " " keys.
–
The parameters for the programmed bias of the selected sewing
distance appear in the display (see display example).
–
Increase or decrease the parameter values in steps by pressing
the "
+
/
-
" keys.
Minimum: 1
Maximum:20
Median value: 10 (straight pocket corner)
Steps: 1 step = 1 stitch of the current stitch condensation
Attention!
The left and right seam rows must always be offset an equal
number of stitches with reference to the median value "
10
".
The parameters
BR
and
BL
to be set for the desired seam offset
can be found in the table on page 14.
The parameters
ER
and
EL
are arrived at in the same manner.
–
Press the "Σ" key.
The cursor moves to the next parameter.
–
Complete the setting procedure by pressing the key for the
selected sewing distance
L1
,
L2
,
L3
or the " " key (for light
barrier seams).
ATTENTION !
With
bias
pockets the following additional setting work must be
conducted:
–
Manually adjust the angle and height of the corner knives
according to the programmed seam offset (see Operating
Instructions)
or:
Switch the corner knives off via the " " key on the controlunit.
15