Operating instructions

11.8 Selecting Input Elements
CAUTION !
All input elements have been carefully set at the factory.
Adjustment and correction may only be undertaken by trained service
personnel.
Program P63 serves for setting the input elements.
–
Set the "
Program
" switch to "
63
".
–
Press the "
STOP
" key.
The program is activated.
–
Set the "
Program
" switch to the code number of the desired input
element.
The short designation in the circuit diagram acts as the code
number (see table). This does not apply for the keys on the front
panel (see "Checking the Front Panel Elements").
–
The display shows the circuit diagram designation and the switch
status of the input element (e.g. "+B14").
–
Adjust the input element (e.g. proximity switch) until the desired
switching status is shown in the display.
The meaning of the switch status corresponds to the switching
status in program P62.
Input Function
Element
b1 Carriage at rear
b2 Reference position
b3 Carriage forward
b4 Folder up
b5 Folder down
b8 Material holder lowered / Vacuum on
(second pedal / Knee switch, optional equipment)
b9 Pedal 3 (External transmitter for sewing drive)
b10 Pedal 4 (External transmitter for sewing drive)
b11 Pedal 1 (External transmitter for sewing drive)
b12 Pedal 2 (External transmitter for sewing drive)
b13 Transmitter control
b14 Thread monitor left
b15 Thread monitor right
b35 Position 1 (Needle down)
b37 Position 2 (Needle up)
b39 (Position 3)
b44 Light barrier NA / NE (optional equipment)
b45 Stacker control
b46 Remaining thread monitor left
b47 Remaining thread monitor right
34