Operating instructions

11.9 Selecting Output Elements
Caution Risk of Injury !
During the function testing of the output elements do not reach into the
running machine.
Program P64 checks the function of the output elements.
–
Move the transport carriage at a distance of 50 mm to its rear end
position by hand.
–
Set the "
Program
" switch to "
64
".
–
Press the "
STOP
" key.
The program is activated.
–
Set the "
Program
" switch to the code number of the desired output
element.
The short designation in the circuit diagram serves as the code
number (see table).
–
Turn the selected output element on and off by tapping the "Σ" key.
Output Function 745-22 745-23 745-24
Element
s1 Raise flap clamp left
XXX
s2 Swing link
XXX
s3 Corner knife seam beginning
XXX
s4 Corner knife seam end
XXX
s5 Close fold plates
XXX
s6 Smoother forward
000
s7 Raise flap clamp right
XXX
s8 Smoother back
000
s9 Stacking / Blowing out
XXX
s10 Raise transport clasp
XXX
s11 Lower transport clasp
XXX
s12 Raise tensioning strip
-X-
s13 Center knife
XXX
s14 Material holder / Vacuum
000
s15 Loosen thread tension
XXX
s16 Open thread clamp
XXX
s17 Close zipper cutter
0- -
* Lower piping reverser
-X-
s18 Pull thread forward
XXX
s19 Blow out lint
XXX
s20 Lower folder
XXX
s21 Raise folder
XXX
s22 Zipper cutter back
0- -
* Knife block forward
-X-
s23 Transport clasp closed
-X-
s24 Thread trimmer / Thread catch
XXX
s25 Needle right and left (745-22;-23)
XX
Needle right (745-24)
X
s26 Needle left
--X
s27 Close tape trimmer
000
s28 Advance tape
000
s29 Raise piping reverser
-X-
* Zipper cutter forward
0- -
s30 Lock hood
XXX
s31 Lift left transport clamp
000
s32 Lower left transport clamp
000
* = Alternative designation with different optional equipment
x
= Standard equipment
0
= Optional equipment
35