Operating instructions

11.12 Positioning the Machine Head in the 1st Needle Position
Operation of the program P67 is as described under program P66.
–
Set the "
Program
" switch to "
67
".
–
Press the "
STOP
" key.
The program is activated.
In contrast to P66:
–
The machine head is positioned in the 1st needle position (needle
down).
The slots in the synchronizer for the two needle positions must be
opposite each other.
11.13 Positioning the Machine Head with Cutting Revolutions
Operation of the program P68 is as described under program P66.
–
Set the "
Program
" switch to "
68
".
–
Press the "
STOP
" key.
The program is activated.
In contrast to P66:
–
The machine head is positioned in the 1st needle position (needle
down).
–
After a short pause the needle is positioned in the 2nd needle
position (needle up).
11.14 Positioning the Machine Head and Thread Trimming
Operation of the program P69 is as described under program P66.
–
Set the "
Program
" switch to "
69
".
–
Press the "
STOP
" key.
The program is activated.
In contrast to P66:
–
The positioning of the machine head in the 2nd needle position
(needle up) occurs with a thread trimming sequence.
37