Instruction manual

- DA321G5321
- 11 -
5.3 Selection of the machine series
Function with or without control panel
Parameter
Display of the machine series
(SEL)
280
The different machine models are characterized by resistors The following resistance values (tolerance 1%)
are provided:
Select resistor
machine model
100
271*, 272*, 273*, 274*, 275*
220
205*
680
069*, 267*, 268*, 269*, 4180, 4280
1000
367*, 381*, 382*, 467*, 767*, 768*, 867
4700
467, 767 as a replacement for DA720V/DA820V
*) For these machine models, the parameter values are prepared. Before commissioning, the settings must
always be checked for suitability for the machine in use.
Select resistor is connected:
Depending on the resistance detected, the special functions for this machine model and the different preset
values are activated. If such a select resistor is connected, it can be read out from parameter 280. The
resistance value is displayed directly in ohms on the control panel. It is not possible to change the value.
Select resistor is not connected:
If no select resistor is connected, the note A5 (emergency run) is displayed. After power on and entry of the
code number, parameter 280 can be used to enter a select resistor value to be assumed. After input is complete
parameter 401 = 1 must be used to store the input. Then the P key must be pressed twice and info A4 appears.
After power is turned off and on again, the select-depending preset value for the corresponding machine model
will be set.
5.3.1 Use of the DA321G5321 as a replacement for DA720V/DA820V
The adapter enables the use of the DA321G controller
on older Dürkopp Adler sewing machines in the
467/767 classes in which the RP20 was used as the
high lift for walking foot potentiometer (built before
1998).
The connection is detected by a selection resistor
(4700 ) in the adapter.
In order to activate appropriate preset values for the
machine class, the corresponding mode must simply
be selected with parameter 290.
Order numbers for the adapter and the adapter cable
for connection of the switch for high lift for walking foot
can be found in the section Special Accessories.