Instruction manual

Instruction Manual
- 14 -
5.7 Maximum speed
Function with or without control panel
Parameter
Maximum speed
(n2)
111
NOTE
See instruction manual of the sewing machine manufacturer for the maximum speed of the sewing machine.
NOTE
Select the pulley such that the motor runs at approx. 4000 RPM with max. number of stitches.
5.8 Positions
Function with or without control panel
Parameter
Setting the reference position
Setting the needle positions
Selection according to position sensor
Transmission ratio between motor shaft and machine shaft
(Sr1)
(Sr2)
(PGm)
(trr)
170
171
270
272
After setting parameter 270 at “1, 2, 3 or 4“, an angular degree must be selected using parameter 171, which
determines the stop in position 2 or 1 after the sensor position. The transmission ratio must already have been
input using parameter 272.
For setting 270 = 6, only the reference position need be set. The angle values are specified accordingly, using
the mode selected with parameter 290.