Instruction manual

- DA321G5321
- 17 -
Setting the reference position on the control
 Input code number and select parameter 170!
 Press the E key

Display
Sr1
 Press the >> key

Display
P o (character o rotating)
Turn handwheel until rotating character
o goes off on the display.

Display
P
 By turning the handwheel, set the
needle to the bottom dead center or the
needle point to the height of the needle
plate in the direction of rotation of the
motor shaft, while needle is moving
downward.

Configuration of the zero point of the machine
 Press the P key once

actual parameter number is displayed
 Press the P key twice

Exit programming at the technician level.
Setting the reference position on the V810 control panel
 Input code number and select parameter 170!
 Press the E key

Display
Sr [o]
 Press the >> key

Display
PoS0 o (character o rotating)
Turn handwheel until rotating character
o goes off on the display.

Display
PoS0
 Set the needle to the bottom dead
center by turning the handwheel.

Configuration of the zero point of the machine
 Press the P key once

actual parameter number is displayed
 Press the P key twice

Exit programming at the technician level.
Setting the reference position on the V820/850 control panel
 Input code number and select parameter 170!
 Press the E key

Display
F-170 Sr1 [o]
 Press the >> key

Display
PoS0 o (character o rotating)
Turn handwheel until rotating character
o goes off on the display.

Display
PoS0
 Set the needle to the bottom dead
center by turning the handwheel.

Configuration of the zero point of the machine
 Press the P key once

actual parameter number is displayed
 Press the P key twice

Exit programming at the technician level.
If error message A3 (reference position not set) appears, repeat the above setting sequence!
5.8.2 Setting the Positions on the Control (Parameter 270 = 0 or 6)
This setting must be set if no reference position was configured or the settings should be changed.
 Input code number and select parameter 171.
 Press the E key

[o] is displayed
 Press the >> key

P1E is displayed; set "position 1 On" on the handwheel
 Press the E key

P2E is displayed; set "position 2 On" on the handwheel
 Press the E key

P1A is displayed; set "position 1 Off" on the handwheel
 Press the E key

P2A is displayed; set "position 2 Off" on the handwheel
 Press the P key twice

Exit programming at the technician level.
*) During turning, the position information is deleted and the angle of the position displayed in degrees
5.8.3 Setting the Positions on the V810 Control Panel (Parameter 270 = 0 or 6)
This setting must be set if no reference position was configured or the settings should be changed.
 Call parameter 188!
E
Press the E key!

F – 1 7 1
F2
Press the F2 key! Actual display.

[ o ]