Instruction manual

Instruction Manual
- 18 -
>>
Press key >> (B key). Display of the 1st parameter
value of position 1

P 1 E 0 0 0
+
-
If necessary, change parameter value by pressing
key >> or +/- or by turning the handwheel

P 1 E X X X
E
Parameter value of position 2 appears on the display

P 2 E 2 5 7
+
-
If necessary, change parameter value by pressing
key >> or +/- or by turning the handwheel

P 2 E X X X
E
Parameter value of position 1A appears on the display

P 1 A 0 7 0
+
-
If necessary, change parameter value by pressing
key >> or +/- or by turning the handwheel

P 1 A X X X
E
Parameter value of position 2A appears on the display

P 2 A 3 3 8
+
-
If necessary, change parameter value by pressing
key >> or +/- or by turning the handwheel

P 2 A X X X
P
P
Press the P key twice! Settings are completed, exit
programming!

d A 3 2 1 G
These values are saved when you begin sewing. They remain in effect even after turning the machine
off!
Storage without starting sewing is possible by using parameter 401!
5.8.4 Setting the Positions on the V820/V850 Control Panel (Parameter 270 = 0 or 6)
This setting must be set if no reference position was configured or the settings should be changed.
Display before programming!

4000 dA321G
P
A parameter number blinks on the display

F-XXX
1
7
1
Input parameter number 171 !

F-171
E
The abbreviation of the parameter appears on the
display

F-171 Sr2 [ o ]
F2
Display of the 1st parameter value of position 1 (B key)

P1E 000
0
…
9
If necessary, change parameter value by pressing keys
+/- or 0...9 or by turning the handwheel.

P1E XXX
E
Parameter value of position 2 appears on the display

P2E 257
0
…
9
If necessary, change parameter value by pressing keys
+/- or 0...9 or by turning the handwheel.

P2E XXX
E
Parameter value of position 1A appears on the display

P1A 070
0
…
9
If necessary, change parameter value by pressing keys
+/- or 0...9 or by turning the handwheel.

P1A XXX
E
Parameter value of position 2A appears on the display

P2A 338
0
…
9
If necessary, change parameter value by pressing keys
+/- or 0...9 or by turning the handwheel.

P1A XXX