Instruction manual

- DA321G5321
- 19 -
P
P
Settings are completed, exit programming!

4000 dA321G
NOTE
When setting the positions by turning the handwheel, make sure that the displayed numerical value changes.
The set values of the position are programmed at the factory. After setting the reference position, the machine
is ready to operate. It is only necessary to change the settings for machines that deviate from the standard
and/or for fine adjustment.
 The unit of the position values set is "degrees".
5.9 Display of the Signal and Stop Positions
Function with or without control panel
Parameter
Display of positions 1 and 2
(Sr3)
172
The position settings can easily be checked by means of parameter 172.
 Select parameter 172
 The control panel display shows "Sr 3"
 Turn handwheel according to the direction of motor rotation
Segment

is turned on
corresponds to position 1
Segment

is turned off
corresponds to position 1A
Segment

is turned on
corresponds to position 2
Segment

is turned off
corresponds to position 2A
V810/V820/V850 control panel display
 Arrow above symbol "position 1" on key 4 (V810) / on key 7 (V820/V850) is displayed corresponds to
position 1
 Arrow above symbol "position 1" on key 4 (V810) / on key 7 (V820/V850) is displayed corresponds to
position 1A
 Arrow above symbol "position 2" on key 4 (V810) / on key 7 (V820/V850) is displayed corresponds to
position 2
 Arrow above symbol "position 2" on key 4 (V810) / on key 7 (V820/V850) is displayed corresponds to
position 2A
If the control panel is connected, the positions will be displayed only on the control panel!