Instruction manual
  - DA321G5321 
- 29 - 
6.6  End ornamental backtack 
Function without control panel 
Control 
Single end ornamental backtack 
Double end ornamental backtack 
End ornamental backtack Off 
Segment 3 on 
Segment 4 on 
Both segments off 
key + (S3) 
Function with control panel 
V810 
V820/V850 
Single end ornamental backtack 
Double end ornamental backtack 
End ornamental backtack Off 
left-hand arrow above key On 
right-hand arrow above key On 
both arrows Off 
Key 2 
Key 4 
Function with or without control panel 
Parameter 
Ornamental backtack stitch count backwards 
Ornamental backtack stitch count forwards 
End backtacking speed 
Function "ornamental backtack" On/Off 
Start delay after disabling the sewing foot lifting signal 
Ornamental backtack stop time 
(SEv) 
(SEr) 
(n4) 
(SrS) 
(t3) 
(tSr) 
082 
083 
113 
135 
202 
210 
The abbreviations set in parentheses ( ) are only visible if a V820/V850 control panel is connected! 
Difference from the standard end backtack: 
  The drive stops for stitch regulator switching 
  The stop time can be set 
  The stitch count of the ornamental backtack can be set with separate parameters. 
Parameter 137 can be used to select the stitch length (normal or long stitch) during the backtack. The display 
does not light up during the backtack. 
137 = 0 
The backtack is executed with a long stitch length. 
137 = 1 
The backtack is executed with a normal stitch length. 
When using the V820/V850 control panel, direct access by means of the function key (key 9) is possible. 
Function with control panel 
Parameter 
Ornamental backtack On/Off 
(-F-) 
008 = 2 
6.7  Multiple backtack 
Function with or without control panel 
Parameter 
Repetitions of the start backtack 
Repetitions of the end backtack 
(wAR) 
(wER) 
090 
091 
After completion of the multiple backtack function, the configured stitch count for the forward or backward 
section of the start or end backtack is repeated according to the value selected with parameter 090/091  
(value 0 = multiple backtack off). 
The function is possible with single or multiple backtacks. 
  Seam direction 
       
 Catch backtack 
 Normal backtack 
 Multiple backtack 










