Instruction manual

- DA321G5321
- 3 -
CONTENTS Page
1 Range of Applications 6
1.1 Use in Accordance with Regulations 6
2 Scope of Supply 6
2.1 Special Accessories 7
3 Putting into Service 8
4 Setting and Putting into Service with the Aid of the Fast Installation Routine (SIR) 8
5 Setting the Basic Functions 10
5.1 Direction of motor rotation 10
5.2 Use of a HSM001 Hall Sensor Module or IPG... Pulse Encoder 10
5.3 Selection of the machine series 11
5.3.1 Use of the DA321G5321 as a replacement for DA720V/DA820V 11
5.3.1.1 Configuration instructions for high lift for walking foot for older Dürkopp Adler sewing
machines (class 467/767) 12
5.3.2 Emergency run function for invalid machine select 12
5.3.3 Selection of machine model using parameter 290 12
5.4 Transmission Ratio 13
5.5 Positioning speed 13
5.6 Maximum Speed Compatible with the Sewing Machine 13
5.7 Maximum speed 14
5.8 Positions 14
5.8.1 Setting the Reference Position (Parameter 270 = 0 or 6) 16
5.8.2 Setting the Positions on the Control (Parameter 270 = 0 or 6) 17
5.8.3 Setting the Positions on the V810 Control Panel (Parameter 270 = 0 or 6) 17
5.8.4 Setting the Positions on the V820/V850 Control Panel (Parameter 270 = 0 or 6) 18
5.9 Display of the Signal and Stop Positions 19
5.10 Positioning shift 20
5.11 Braking Characteristics 20
5.12 Braking Power at Standstill 20
5.13 Starting Characteristics 20
5.14 Actual Speed Display 20
5.15 Operating Hours Counter 21
5.15.1 Set and Reset Operating Hours Counter 22
5.15.2 Total Operating Hours Display 22
6 Functions with or without Control Panel 23
6.1 Softstart 23
6.2 Sewing foot lifting 23
6.2.1 Sewing foot lifting on workstations with standing operator 24
6.3 Start backtack 25
6.3.1 Speed n3 at the Start of the Seam 25
6.3.2 Stitch counting for start backtack 25
6.3.3 Stitch Correction and Speed Release 26
6.3.4 Double start backtack 26
6.3.5 Single start backtack 26
6.4 End backtack 26
6.4.1 Speed n4 at the Seam End 27
6.4.2 Stitch Counting for End Backtack 27
6.4.3 Stitch correction of the double end backtack 27
6.4.4 Double end backtack 27
6.4.5 Single end backtack 27
6.4.6 Backtack Synchronization 28
6.5 Start ornamental backtack 28