Instruction manual

- DA321G5321
- 33 -
In the free seam:
 Fastest possible stop without positioning.
 Trimming is not possible.
 After lifting of the machine run block, pedal > 1 continues the seam, or pedal –2 starts thread trimming.
In stitch counting:
 Fastest possible stop without positioning. Stitch counting is interrupted.
 Trimming is not possible.
 After lifting of the machine run block, pedal > 1 continues the stitch counting, or pedal –2 starts thread
trimming.
During light barrier compensation stitches:
 Fastest possible stop without positioning. The light barrier compensation stitches are interrupted.
 Trimming is not possible.
 After lifting of the machine run block, pedal > 1 continues the light barrier compensating stitches, or pedal –
2 starts thread trimming.
In the end backtack:
 Fastest possible stop without positioning. The end backtack is interrupted.
 Trimming is not possible.
 After lifting of the machine run block, pedal > 1 continues the end backtack, or pedal –2 starts thread
trimming.
6.14.3 Machine run block function 2 (safety function) parameter 283 = 2
In start backtack, in stitch counting, and in light barrier compensation stitches:
 Stop in the selected position.
 Cutting without an end backtack with pedal –2 with machine run block active is possible. If cutting is done
with run block active, a new seam is started after the machine run block is lifted.
 After lifting of the machine run block, pedal > 1 continues the start backtack or the stitch counting, or pedal –
2 starts thread trimming.
in the free seam:
 Stop in the selected position.
 Cutting without an end backtack with pedal –2 with machine run block active is possible. If cutting is done
with run block active, a new seam is started after the machine run block is lifted.
 After lifting of the machine run block, pedal > 1 continues the seam, or pedal –2 starts thread trimming.
In the end backtack:
 The end backtack runs until the end with stop in the selected position. The start of the next seam is blocked.
 Cutting with pedal –2 with machine run block active is possible.
 After lifting of the machine run block, pedal -1 with thread trimming the seam process ends, if this was not
yet done.
 If cutting is done with run block active, a new seam is started after the machine run block is lifted.
During thread trimming:
 Thread trimming runs to its end. The start of the next seam is blocked.
 After the machine run block is lifted, the start of the next seam is released.