Instruction manual

Instruction Manual
- 40 -
6.17.7 Edge trimmer manual (Function module A)
Function with or without control panel
Parameter
Edge trimmer manual (output A)
Keep A after seam end or delete it
(FMA)
(AFA)
250 = 8
251
Activation of output A turns the edge trimmer on. If the setting of parameter 251 = 1, the edge trimmer is turned
off after thread trimming.
 After power-on, the edge trimmer and LED A are turned off.
 By pressing key A, the edge trimmer can be turned on at any time (output A and LED A on).
 When the key is pressed again, the edge trimmer is turned off (output A and LED A off).
 If the parameter 251 = 1, the edge trimmer is activated after thread trimming, as well as after power-on.
Output
A
LED A
Remark
power On
Off
Off
Edge trimmer off
Press key A
On
On
Edge trimmer on
Press key A again
Off
Off
Edge trimmer off
After thread trimming if parameter 251 = 1
Off
Off
Edge trimmer off
6.17.8 Edge trimmer automatic (Function module A)
Function with or without control panel
Parameter
Edge trimmer automatic (Output A)
Edge trimmer kept at seam end and before thread trimming or it is set as it is after
power-on
Stitch count until edge trimmer turned on
Stitch count until edge trimmer turned off
Coupling of the sewing foot lifting with the edge trimmer
(FMA)
(AFA)
(cA)
(cA_)
(kFk)
250 = 9
251
253
254
267
Activation of output A (M6 on socket A/30) turns the edge trimmer on. LED A is used as the display (M10 on
socket A/29). The activation point of the edge trimmer is set using parameter 253 (stitch count). The duty ratio of
the edge trimmer is set using parameter 254 (stitch count).
Possible operating states:
Parameter
or parameter
Automatic operation
253 >0, 254 >0, 251 = 0
251 = 1
Semi-automatic operation
253 >0, 254 = 0, 251 = 0
251 = 1
253 = 0, 254 >0, 251 = 0
251 = 1
Manual operation
253 = 0, 254 = 0,251 = 0
251 = 1
251 = 0
The switch state of the edge trimmer remains that of before thread trimming.
251 = 1
The switch state of the edge trimmer is set as it is after power on.
267 = 0
The state of the edge trimmer (on or off) remains unchanged during sewing foot lifting
267 = 1
The edge trimmer is turned off when the sewing foot is lifted.
267 = 2
The edge trimmer is turned off when the sewing foot is lifted and can be turned back on by pressing the key.