Instruction manual

Instruction Manual
- 46 -
F2
Press the F2 key!

ZZZZ XX AB YY
 Set high lift for walking foot (potentiometer on the machine) to the level up to which full speed is to be
maintained (upper break point).
E
New value of AB is taken over to XX.

ZZZZ XX AB YY
 Set high lift for walking foot (potentiometer on the machine) to the level up to which full speed is to be
maintained (lower break point).
E
New value of AB is taken over to YY.

ZZZZ XX AB YY
 Press the P key once  Actual parameter is displayed! Press the P key twice.  Programming is complete!
6.19.5 Setting the Speed Limitation Depending on High Lift with the V810 Control
Panel
 Call parameter 188!
E
Press the E key!

hP [ o ]
F2
Press the F2 key! Actual display.

1 1. 3 2 0 0
F2
Press the F2 key! Previous values are displayed.

0 5 1 9
F2
Press the F2 key!

1 1. 3 2 0 0
Set new value (level) with potentiometer on the
machine.

0 8. 3 2 0 0
F2
Press the F2 key!

0 5 1 9
E
Press the E key! New value 08 (upper break point) 
is accepted!

0 8 0 8
F2
Press the F2 key!

0 8. 3 2 0 0
Set new value (level) with potentiometer on the
machine.

1 7. 3 2 0 0
F2
Press the F2 key!

0 8 0 8
E
Press the E key! New value 17 (lower break point) 
is accepted!

0 8 1 7
P
Press the P key once. Display of current parameter
number.

F – 1 8 8
or
P
P
Press the P key twice. Exit programming.

d A 3 2 1 G
These values are saved when you begin sewing. They remain in effect even after turning the machine
off!
NOTE
If you set a value on the potentiometer, which is between the actual break points, both values will be
overwritten when the E key is pressed. Only after that is it possible to program new lower and/or upper break
point values.