Instruction manual

Instruction Manual
- 54 -
16 Intermediate backtack / intermediate stitch condensing:
Upon pressing the key, the backtack or stitch condensing will be enabled anywhere in the seam and at
standstill of the drive.
17 Stitch Regulator Suppression/Recall:
Upon pressing the key, the backtack or stitch condensing operation will be suppressed or recalled once.
18 Thread tension reduction
19 Reset bobbin thread monitor:
After inserting a full bobbin, the stitch counter is set to the configured value when the key is pressed.
(Parameter 195=4)
20 Handwheel running in the direction of rotation:
When the key is pressed, the drive runs (Parameter 161=0).
21 Handwheel running in the direction of rotation:
When the key is pressed, the drive runs in the opposite direction (Parameter 161).
22 Switch stitch length
23 Transport roller
24 No function
25 DB2000:
When the key is pressed, the drive runs with a fixed speed n10 (DB2000)
26 Input of speed limitation n11 (DB3000)
27 Input of speed limitation n10 (DB2000)
28 External light barrier:
In this mode it is possible to initiate the seam end using a key, not the light barrier. But the light barrier
function must be On.
29 Single stitch with stitch length switching
30 Emergency stop:
After the key is pressed, the drive stops in position 2. The sewing foot is lifted. On the V820/V850, the run
block symbol flashes; on the V810 "Stop" flashes. The drive functions are blocked. Only after power-off/on
is the drive again ready to use.
31...38 No function
39 Switch to the next pattern in TEACH IN:
Upon pressing the key, the program switches to the next pattern.
40 Switch back to the previous pattern TEACH IN:
Upon pressing the key, the program switches to the previous pattern.
41...45 No function
46 Key for function module A
47 Key for function module B
48 Signal A1 is issued:
Upon pressing the key, signal A1 is issued immediately.
49 Signal A1 switchable as flip-flop:
Upon pressing the key, signal A1 is activated and deactivated when pressing the key again.
50 No function
51 Signal A2 is issued:
Upon pressing the key, signal A2 is issued immediately.
52 Signal A2 switchable as flip-flop:
Upon pressing the key, signal A2 is activated and deactivated when the key is pressed again.
53 No function
54 No function
55 Reversal of the direction of rotation
56 No function
57 No function
58 Intermediate backtack latching
59...77 No function
78 Switching of the high lift for walking foot function latching/keyed
79...88 No function