Instruction manual

Instruction Manual
- 58 -
Function with or without control panel
Parameter
Speed stage graduation
(nSt)
119
The pedal characteristics (speed change from stage to stage) can be varied.
Possible characteristic curves:
- linear
- progressive
- highly progressive
6.33.2 Analog actuator
Function with or without control panel
Parameter
Characteristic of the "analog pedal"
(APd)
026
The effect of pedal actuation on the drive functions can be set using parameter 026:
026 = 0
Analog function off
026 = 1
12-level selected, like prior pedal function of the digital actuator.
026 = 2
continuously variable
026 = 3
24-level
026 = 4
60-level (progressive)
026 = 5
60-level (progressive)
6.33.3 Frequency-controlled speed specification
Instead of speed specifications using a target value sensor, this can also be done by applying a frequency to
input C (B80/4). The frequency between 200 and 10,000 Hz determines the set value in the range bounded by
parameters 110/111 (positioning speed/maximum speed).
Start / stop takes place through input D (B80/7).
Foot lifting and thread trimming take place via inputs A and B (B80/8 and 6) according to the table above.
6.34 Acoustic Signal
Function with control panel
Parameter
Acoustic signal On/Off
(AkS)
127
An acoustic signal which sounds in the following cases can be enabled by means of parameter 127:
 When the machine run blockage is On.