Instruction manual

Instruction Manual
- 6 -
1 Range of Applications
The drive is suitable for lockstitch and chainstitch machines Dürkopp Adler, for different models.
It can be operated with or without control panel.
The easy-to use V810, V820 or V850 control panels extend the range of functions.
Further control functions can be programmed using the Efka Compiler C200 software and the user-friendly
V900 touchscreen panel.
Stepping motor mode is also possible in combination with the Efka SM210A controller.
1.1 Use in Accordance with Regulations
The drive is not an independently operating machine, but is designed to be incorporated into other machinery by
specially trained personnel.
It must not be put into service until the machinery into which it is to be incorporated has been declared in
conformity with the provisions of the EC Directive (Appendix II, paragraph B of the Directive 89/392/EEC and
supplement 91/368/EEC).
The drive has been developed and manufactured in accordance with the relevant EC standards:
IEC/EN 60204-31 Electrical equipment of industrial machines:
Particular requirements for industrial sewing machines, sewing units and sewing systems.
Operate the drive only in dry areas.
ATTENTION
When selecting the installation site and the layout of the connecting cable, the Safety
Instructions must be followed with no exceptions.
Particular attention should be paid to maintaining the proper distance from moving parts!
2 Scope of Supply
Standard Scope of Supply
1
Direct current motor
DC1550
1
Electronic control/Power supply unit
DA321G5321/N208
1
Actuator
EB301A
1
Set of accessories (standard)
B158
consisting of:
Plastic bag for B156 + documentation
Option 1
1
Set of standard accessories
B156
consisting of:
Plastic bag for B156 and documentation
Option 2
1
Set of standard accessories
B159
consisting of:
Plastic bag for B159, documentation
and motor mounting parts
and
1
Set of accessories
Z54
consisting of:
Pitman rod 400...700mm long
Table mounting for EB3..
NOTE
If there is no metallical contact between drive (motor) and machine head, the potential equalization cord
supplied with the unit is to be wired from the machine head to the terminal provided on the control box!