Instruction manual

Instruction Manual
- 8 -
F-290
End SIR
F-272
Pos 0
F-161
P
E
E
E
P
E
F-280
F-500
Code 3112
F-200
E
E
E
No
Yes
KL2547
>>
>>
F-170
3 Putting into Service
Before putting the control into service, the following must be ensured, checked and/or adjusted:
 The correct installation of the drive, position transmitter and accompanying devices, if necessary
 If necessary, the correct adjustment of the direction of motor rotation using parameter 161
 The correct positioning speed using parameter 110
 The correct maximum speed compatible with the sewing machine using parameter 111
 Configuration of the positions
 The setting of the remaining relevant parameters
 Begin sewing in order to save the set values
4 Setting and Putting into Service with the Aid of the Fast Installation
Routine (SIR)
The Fast Installation Routine (SIR) passes through all parameters
necessary for programming the functional sequence and the positions.
Input parameter 500 (call-up SIR) 
Display of the select resistor
Enter machine model for the select resistor detected
Parameter for direction of motor rotation
Parameter for transmission ratio
(Important! The transmission ratio should be determined and
indicated as precisely as possible.)
Setting the reference position
The values can be varied by pressing key +/-. When the parameter is
displayed on the V810 control panel, press the E key once more for the
value to be displayed.