User`s manual
Table Of Contents
- M-322
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Connectors & Jumpers
- 2.1 Rear I/O Connectors
- 2.2 Onboard Connectors
- Front Panel Audio Pin Header (AAFP)
- ATX 12V Power Connector (ATX12V)
- ATX Power Connector (EATXPWR)
- CD-in Connector (CD)
- System Fan Connector (CHA_FAN1)
- CPU Fan Connector (CPU_FAN)
- Chassis Intrusion Connector (CHASSIS)
- Serial Port Connectors RS-232 (COM2-4)
- Serial Port Connectors RS-422/485 (COM4)
- Floppy Disk Drive Connector (FLOPPY)
- System Panel Pin Header (F_PANEL)
- Amplifier Audio Pin Header (JAMP1)
- Digital IO Pin Header (JDIO)
- IDE Connector (PRI_EIDE)
- Power Fan Connector (PWR_FAN)
- SATA Connectors (SATA1-6)
- S/PDIF Pin Header (SPDIF_OUT)
- SPI Pin Header (SPI)
- USB Pin Headers (USB56/78/910/1112)
- 2.3 Jumpers
- 3 Getting Started
- 4 BIOS Setup
- 4.1 Starting the BIOS
- 4.2 Main Setup
- 4.3 Advanced Setings
- 4.3.1 USB Configuration
- 4.3.2 Trusted Computing
- 4.3.3 Intel TXT Configuration
- 4.3.4 Intel VT-d Configuration
- 4.3.5 CPU Configuration
- 4.3.6 Chipset Settings
- North Bridge Configuration
- 4.4 Power Settings
- 4.5 Boot Settings
- 4.6 Exit Menu
- Appendix A - Watchdog Timer
- Appendix B - System Resources
- Important Safety Instructions
- Getting Service
22 Connectors & Jumpers
IDE Connector (PRI_EIDE)
Power Fan Connector (PWR_FAN)
Pin # Signal Pin # Signal
1 Reset 2 Ground
3 Data 7 4 Data 8
5 Data 6 6 Data 9
7 Data 5 8 Data 10
9 Data 4 10 Data 11
11 Data 3 12 Data 12
13 Data 2 14 Data 13
15 Data 1 16 Data 14
17 Data 0 18 Data 15
19 Ground 20 -
21 Request 22 Ground
23 I/O Write 24 Ground
25 I/O Read 26 Ground
27 I/O Ready 28 Cable Select
29 DMA Ack 30 Ground
31 Interrupt Request 32 No Connect
33 Device Address 1 34 ATA 66/100 Detect
35 Device Address 0 36 Device Address 2
37 Chip Select 1 38 Chip Select 3
39 Device Active 40 Ground
Pin # Signal
1 Fan Sense
2 Fan Power (+12V)
3 GND
31