User`s manual
Table Of Contents
- M-322
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Connectors & Jumpers
- 2.1 Rear I/O Connectors
- 2.2 Onboard Connectors
- Front Panel Audio Pin Header (AAFP)
- ATX 12V Power Connector (ATX12V)
- ATX Power Connector (EATXPWR)
- CD-in Connector (CD)
- System Fan Connector (CHA_FAN1)
- CPU Fan Connector (CPU_FAN)
- Chassis Intrusion Connector (CHASSIS)
- Serial Port Connectors RS-232 (COM2-4)
- Serial Port Connectors RS-422/485 (COM4)
- Floppy Disk Drive Connector (FLOPPY)
- System Panel Pin Header (F_PANEL)
- Amplifier Audio Pin Header (JAMP1)
- Digital IO Pin Header (JDIO)
- IDE Connector (PRI_EIDE)
- Power Fan Connector (PWR_FAN)
- SATA Connectors (SATA1-6)
- S/PDIF Pin Header (SPDIF_OUT)
- SPI Pin Header (SPI)
- USB Pin Headers (USB56/78/910/1112)
- 2.3 Jumpers
- 3 Getting Started
- 4 BIOS Setup
- 4.1 Starting the BIOS
- 4.2 Main Setup
- 4.3 Advanced Setings
- 4.3.1 USB Configuration
- 4.3.2 Trusted Computing
- 4.3.3 Intel TXT Configuration
- 4.3.4 Intel VT-d Configuration
- 4.3.5 CPU Configuration
- 4.3.6 Chipset Settings
- North Bridge Configuration
- 4.4 Power Settings
- 4.5 Boot Settings
- 4.6 Exit Menu
- Appendix A - Watchdog Timer
- Appendix B - System Resources
- Important Safety Instructions
- Getting Service
34 Getting Started
3.4 Driver Installation
This section provides information on how to install the M-322
device drivers under Windows XP. The device drivers are located
in the following directories on the driver CD, or can be downloaded
from the ADLINK website (http://www.adlinktech.com):
Install the Windows operating system before installing any driver.
Most standard I/O device drivers are installed during Windows
installation.
Intel® Matrix Storage Technology Driver
1. Create a floppy image as described in the F6Readme.txt file
contained in X:\Intel Matrix Storage Manager\Floppy_32.
2. During Windows installation, press F6 when you see the
message “Press F6 if you need to install a third party
SCSI or RAID driver.” Then press S to Specify Additional
Device.
3. Insert the floppy disk and follow the remaining instruc-
tions. Leave the disk in until the system has rebooted
and copied the necessary files, then remove the disk.
Chipset \Drv_Chipset_Q35\
Display \Drv_VGA_GMA3100\
Ethernet \Drv_Lan_RTL8111C\
Audio \Drv_Audio_ALC888\
TPM \TPM\
Matrix Technology \Intel Matrix Storage Manager\
NOTE:
NOTE:
In order to enable RAID or AHCI mode, you must pre-install the
Intel® Matrix Storage Technology driver during the Windows*
installation process. using the F6 installation method.
*Not required for Windows Vista and Windows 7.