User`s manual
Table Of Contents
- M-322
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Connectors & Jumpers
- 2.1 Rear I/O Connectors
- 2.2 Onboard Connectors
- Front Panel Audio Pin Header (AAFP)
- ATX 12V Power Connector (ATX12V)
- ATX Power Connector (EATXPWR)
- CD-in Connector (CD)
- System Fan Connector (CHA_FAN1)
- CPU Fan Connector (CPU_FAN)
- Chassis Intrusion Connector (CHASSIS)
- Serial Port Connectors RS-232 (COM2-4)
- Serial Port Connectors RS-422/485 (COM4)
- Floppy Disk Drive Connector (FLOPPY)
- System Panel Pin Header (F_PANEL)
- Amplifier Audio Pin Header (JAMP1)
- Digital IO Pin Header (JDIO)
- IDE Connector (PRI_EIDE)
- Power Fan Connector (PWR_FAN)
- SATA Connectors (SATA1-6)
- S/PDIF Pin Header (SPDIF_OUT)
- SPI Pin Header (SPI)
- USB Pin Headers (USB56/78/910/1112)
- 2.3 Jumpers
- 3 Getting Started
- 4 BIOS Setup
- 4.1 Starting the BIOS
- 4.2 Main Setup
- 4.3 Advanced Setings
- 4.3.1 USB Configuration
- 4.3.2 Trusted Computing
- 4.3.3 Intel TXT Configuration
- 4.3.4 Intel VT-d Configuration
- 4.3.5 CPU Configuration
- 4.3.6 Chipset Settings
- North Bridge Configuration
- 4.4 Power Settings
- 4.5 Boot Settings
- 4.6 Exit Menu
- Appendix A - Watchdog Timer
- Appendix B - System Resources
- Important Safety Instructions
- Getting Service
BIOS Setup 43
M-322
SATA Configuration
SATA Configuration
Allows you to disable or enable SATA Configuration function.
Options: [Disabled], [Compatible], [Enhanced]
Configure SATA as
Configures the Serial ATA connectors supported by the South-
bridge chip. The AHCI allows the onboard storage drive to
enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to
internally optimize the order of commands. If you want to cre-
ate a RAID 0, RAID 1, RAID 5, RAID 10, or the Intel® Matrix
Storage Technology configuration from the Serial ATA hard disk
drives, set this item to [RAID].
Hard Disk Write Protect
Allows you to enable or disable the hard disk write protect.
Options: [Disabled], [Enabled]
IDE Detect Time Out
Sets SATA detect time out.
Options: [0], [5], [10], [15], [20], [25], [30], [35]