User`s manual
Table Of Contents
- M-322
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Connectors & Jumpers
- 2.1 Rear I/O Connectors
- 2.2 Onboard Connectors
- Front Panel Audio Pin Header (AAFP)
- ATX 12V Power Connector (ATX12V)
- ATX Power Connector (EATXPWR)
- CD-in Connector (CD)
- System Fan Connector (CHA_FAN1)
- CPU Fan Connector (CPU_FAN)
- Chassis Intrusion Connector (CHASSIS)
- Serial Port Connectors RS-232 (COM2-4)
- Serial Port Connectors RS-422/485 (COM4)
- Floppy Disk Drive Connector (FLOPPY)
- System Panel Pin Header (F_PANEL)
- Amplifier Audio Pin Header (JAMP1)
- Digital IO Pin Header (JDIO)
- IDE Connector (PRI_EIDE)
- Power Fan Connector (PWR_FAN)
- SATA Connectors (SATA1-6)
- S/PDIF Pin Header (SPDIF_OUT)
- SPI Pin Header (SPI)
- USB Pin Headers (USB56/78/910/1112)
- 2.3 Jumpers
- 3 Getting Started
- 4 BIOS Setup
- 4.1 Starting the BIOS
- 4.2 Main Setup
- 4.3 Advanced Setings
- 4.3.1 USB Configuration
- 4.3.2 Trusted Computing
- 4.3.3 Intel TXT Configuration
- 4.3.4 Intel VT-d Configuration
- 4.3.5 CPU Configuration
- 4.3.6 Chipset Settings
- North Bridge Configuration
- 4.4 Power Settings
- 4.5 Boot Settings
- 4.6 Exit Menu
- Appendix A - Watchdog Timer
- Appendix B - System Resources
- Important Safety Instructions
- Getting Service
52 BIOS Setup
4.3.6 Chipset Settings
The Chipset menu allows you to change the advanced chipset set-
tings. Select an item then press <Enter> to display the sub-menu.
North Bridge Configuration
Memory Remap Feature
Allows you to enable or disable the remapping of the over-
lapped PCI memory above the total physical memory. Enable
this option only when you install a 64-bit operating system.
Options: [Disabled], [Enabled].
Initial Graphic Adapter
Allows you to select which graphics controller to use as the pri-
mary boot device.
Options: [IGD], [PCI/IGD], [PCI/PEG], [PEG/IGD], [PEG/PCI]