Specifications

3-6 Initialization & Installation
3. 3. Set Configuration
@Description
Configure the basic setting of NuDAM, including the address ID,
output signal range, baud rate, and data format. The new
configuration will be available after executing the command.
@Syntax
%(OldAddr)(NewAddr)(OutputRange)(BaudRate)(DataFormat)<CR>
% Command leading code. (1-
character)
(OldAddr)
NuDAM module original address ID. The
default address ID of a brand new module
is 01. The value range of address ID is 00
to FF in hexadecimal. (2-character)
(NewAddr)
New address ID, if you don’t want to
change address ID, let new address ID
equals to the old one. (2-character)
(OutputRange)
Define analog output range, refers to
Table 3-1 for details. (2-character)
(BaudRate)
Define communication baud rate, refers
to Table 3-2 for details. (2-character)
(DataFormat)
Define checksum, integration time and
output data format, refers to Figure 3-1
for details. (2-character)
@Response
!(Addr)<CR>
or
?(Addr)<CR>
(Addr)
Address ID.
!
Command is valid.
?
Command is invalid, parameter values are
invalid, or change the setting without grounding
the DEFAULT* pin.