User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
10 Introduction
1.8 I/O Connectivity
I/O Bracket Onboard
Golden
Finger
Remarks
USB1 Y — —
VGA Y — — DB-15
GbE1 (RJ-45) Y (with LED
indication)
——
Act/Link/Speed
GbE2 (RJ-45) Y (with LED
indication)
——
Act/Link/Speed
PS/2 KB/MS1*
Y———
KB/MS — Y — 2.54 pitch
USB2/3 — Y — 2.54 pitch
USB4/5 — Y — 2.54 pitch
COM1/2 — Y — 2.54 pitch
Printer port — Y — —
IDE — Y — —
Floppy — Y — —
SATA-300 1/2 — Y — —
ISA — — Y —
PCI 32-bit/33 MHz — — Y 4 slots
NOTE:
NOTE:
* Not supported on boards with ordering numbers ending in
“xx40” and higher. See “PS/2 Keyboard/Mouse Port” on
page 14 for more information.