User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
50 BIOS Setup
5.3.4 Super IO Configuration
You can use this screen to select options for the Super IO settings.
Use the up and down < Arrow > keys to select an item. Use the <
+ > and < - > keys to change the value of the selected option. The
settings are described on the following pages. The screen is
shown below.
Onboard Floppy Controller
Options: Disabled, Enabled
Serial Port1 Address
Select an address and a corresponding interrupt for Serial
Port1. Options: 3F8/IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3.
Serial Port2 Address
This option specifies the base I/O port address and Interrupt
Request address of Serial Port2. The settings of Serial Port2
are the same as Serial Port1. However, the setting used by
Serial Port1 will not be available for Serial Port2. For example,