User`s manual

Appendix • 75
Appendix B: Standard Compliance
Notice for USA
Compliance Information Statement (Declaration of
Conformity Procedure) DoC FCC Part 15
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation or when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Notice for Europe
This product is in conformity with the Council Directive
89/336/EEC amended by 92/31/EEC and 93/68/EEC
This equipment has been tested and found to comply with
EN55022/CISPR22 and EN55024/CISPR24. To meet EC requirements,
shielded cables must be used to connect a peripheral to the card. This
product has been tested in a typical class B compliant host system. It is
assumed that this product will also achieve compliance in any class A
compliant unit.