User's Manual

Getting Started 15

STC-1005/ 1205/ 1505

3 Getting Started

3.1 Panel Mounting

The STC-1005/1205/1505 can be panel mounted using the

8 brackets included with the device. Make sure there is adequate

space behind the panel for ventilation, and that the panel material

and thickness can support the weight of the device.

1. Cut the panel opening using the appropriate cutout

dimensions shown below.

2. Install the panel mount brackets onto the back of the

device as shown in Figure 3-1 below.

3. Attach I/O cables to the device before installing into the

panel if rear access will be limited after installation (see

“I/O Panel Layout” on page 9.).

4. Place the device into the panel cutout.

5. Hand-tighten the mounting brackets with a Phillips-head

screwdriver to secure it to the panel. Do not overtighten

the brackets to avoid damaging the device enclosure.

NOTE:

The mounting brackets can accommodate a maximum panel

thickness of 2 mm.

CAUTION:

Do not overtighten the brackets as this may damage the device

enclosure.Always tighten the mounting brackets BY HAND to

secure it to the panel.