Owner's manual

aTCA-N700 SW Users Guide
２７








Boot-up with new U-Boot image, U-Boot environment variables should be updated, as
shown below.











5.5.2. Installing NP
LMP boot-up using ramdisk image and np-installer script on the ramdisk image should
be used to install all NP deliverables (U-Boot, kernel, and rootfs). The script installs NP
deliverables using a PCIe channel.
Run tftpboot on lmp U-Boot, like below. This is same as the installing LMP procedure
(previous chapter).






       
      



After LMP Linux boot-up using ramdisk image is completed, edit and run np-installer on
linux, as shown below. The MAC address for each management port of NP process
should be provided.





 
