User Manual

Module Description 41
CM1-86DX2
The GPIOs on X17 are 5V tolerant. So you can connect up to 5V to these GPIOs.
X17 Connector type
: Hirose, DF13_10P-1.25H
X21 Connector type
: Hirose, DF13_12P-1.25H
The reference voltage is not intended to supply equipment other than low power
equipment (Imax < 150 mA).
The 8 analog channels are multiplexed through one conversion engine. So the sample
rate is shared. This means the more channels that are active, the less the individual
sample rate per channel will be.
Table 3-25: GPIO Signals (X17 and X21)
Pin GPIO/COM6, X17 Pin Analog-In, X21
1 GP1_VCC (5.0 V) 1 ADC_VCC (3.3 V)
2 GND 2 GND
3 GP10_DCD6# 3 ADC0
4 GP11_SOUT6 4 ADC1
5 GP12_RTS6# 5 ADC2
6 GP13_RI6# 6 ADC3
7 GP14_SIN6 7 ADC4
8 GP15_DTR6# 8 ADC5
9 GP16_DSR6# 9 ADC6
10 GP17_CTS6# 10 ADC7
11 I2C0_CLK
12 I2C0_DATA