Instruction Manual
Table Of Contents
- CSA-5200
- Revision History
- Table of Contents
- 1 Overview
- 2 Specifications
- 3 Getting Started
- 4 System Interfaces
- 4.1 Front Panel I/O
- 4.2 Board Layout
- 4.3 Connectors and Jumpers
- 4.3.1 PCIe x4 Connector (PCIE1)
- 4.3.2 CFast Connector (CN17)
- 4.3.3 VGA Header (CNX1)
- 4.3.4 ATX12V Connector (CN24)
- 4.3.5 Fan Connectors (FAN1/FAN6-9)
- 4.3.6 ATX Connector (CN19)
- 4.3.7 mSATA Connectors (CN9/CN48)
- 4.3.8 SATA Connectors (CN30-33)
- 4.3.9 SATADOM Power Connector (CN18, Wafer 1.25mm pitch)
- Clear CMOS Jumper (JBAT1)
- 4.3.11 NIM Slot connectors (PCI1-4)
- 5 LAN Bypass Function
- 6 Watchdog Timer Programming
- 7 BIOS Setup
- Safety Instructions
- Consignes de Sécurité Importantes
- Getting Service
5
CSA-5200
1 Overview
1.1 Introduction
The ADLINK CSA-5200 is a 2U 19" rackmount Network Appliance with 4th Generation Intel®
processor Xeon® E3-1200 v3 and Intel® C226 Chipset. The CSA-5200 features up to 32x
GbE ports or 8x SFP+ with an I/O intensive architecture, high scalability with four Network
Interface Module (NIM) slots, 2.5’’/3.5’’ SATA drive bays, additional storage interfaces
(SATADOM, CFast), and is an ideal platform for communications infrastructure deployment.
Detailed features are outlined below and a functional block diagram is shown in the next
section.
4th Gen Intel® processor Xeon® E3-1200 v3 with Intel® C226 Chipset
• Intel® Xeon® E3-1275 v3 (4C/8T)
• Intel® Xeon® E3-1225 v3 (4C/4T)
• Intel® Core™ i3-4330 (2C/4T)
8MB/4M/3M/2M L2 cache, depending on CPU
4x DDR3-1066/1333/1600 240-pin DIMM sockets, non-ECC, up to 32 GB
Up to 32x GbE ports or 8x SFP+ with I/O intensive architecture
High scalability with four Network Interface Module (NIM) slots
Four 2.5’’/3.5’’ SATA drive bays
Additional storage interfaces: SATADOM, CFast
2U 19’’ rackmount form factor for communications infrastructure deployment