Owner's manual
Table Of Contents
- ETX-CV
- Revision History
- Table of Contents
- Preface
- 1 Introduction
- 2 Specifications
- 3 Function Diagram
- 4 Mechanical Dimensions
- 5 Embedded Functions
- 6 Pin-out and Signal Descriptions
- 7 System Resources
- 8 BIOS Setup Utility
- 9 BIOS Checkpoints, Beep Codes
- Appendix A: Connectors and Mounting
- Important Safety Instructions
- Getting Service
ETX-CV User’s ManualPage 54
8.3.8 W83627DHG Super IO Configuration
You can use this screen to select options for the Super IO settings. Use the up and down < Arrow
> keys to select an item. Use the < + > and < - > keys to change the value of the selected option.
The settings are described on the following pages. The screen is shown below.
Serial Port 0,1 Configuration
Set Parameters of Serial Port 0, 1 (COM 1/2). Set this value to Enabled/Disabled.
Change Settings
This option specifies the base I/O port address and interrupt request address of Serial Port 0, 1
(COM 1/2). Options shown below.