Owner's manual
Table Of Contents
- ETX-CV
- Revision History
- Table of Contents
- Preface
- 1 Introduction
- 2 Specifications
- 3 Function Diagram
- 4 Mechanical Dimensions
- 5 Embedded Functions
- 6 Pin-out and Signal Descriptions
- 7 System Resources
- 8 BIOS Setup Utility
- 9 BIOS Checkpoints, Beep Codes
- Appendix A: Connectors and Mounting
- Important Safety Instructions
- Getting Service
ETX-CV User’s ManualPage 80
A.3 Mounting Procedures
There are several standard ways to mount an ETX board with heatspreader on a carrier board.
ETX boards may be mounted with 9.5 mm ETX connectors on the carrier board or standard 3
mm connectors. There are also two different types of heatspreaders to choose from:
heatspreaders with threaded standoffs which require inserting screws from under the carrier, or
top mounting heatspreaders using through-hole heatspreader standoffs and threaded carrier
board standoffs.
Heatspreader
ETX Module
Carrier
M2.5: 16 mm
with spring/washer
6 mm through-hole
standoffs
3 mm threaded
standoff (DIP)
Heatspreader
ETX Module
Carrier
M2.5: 16 mm
with spring/washer
6 mm threaded
standoffs
3 mm through-hole
standoff (SMT)
Top Mounting
3 mm Hirose FX8-100S-SV
Carrier Board Connectors
Bottom Mounting
3 mm Hirose FX8-100S-SV
Carrier Board Connectors
Top Mounting
9.5 mm Hirose FX8C-100S-SV5
Carrier Board Connectors
Heatspreader
ETX Module
Carrier
M2.5: 14 mm
with spring/washer
6 mm through-hole
standoffs
9.5 mm threaded
standoff (DIP)
Heatspreader
ETX Module
Carrier
M2.5: 16 mm
with spring/washer
6 mm threaded
standoffs
9.5 mm through-hole
standoff (SMT)
Bottom Mounting
9.5 mm Hirose FX8C-100S-SV5
Carrier Board Connectors