Owner's manual
Table Of Contents
- ETX-CV
- Revision History
- Table of Contents
- Preface
- 1 Introduction
- 2 Specifications
- 3 Function Diagram
- 4 Mechanical Dimensions
- 5 Embedded Functions
- 6 Pin-out and Signal Descriptions
- 7 System Resources
- 8 BIOS Setup Utility
- 9 BIOS Checkpoints, Beep Codes
- Appendix A: Connectors and Mounting
- Important Safety Instructions
- Getting Service
ETX-CV User’s Manual Page 81
ETX-CV User’s Manual Page 81
33-72000-0030
33-72011-0030
33-72007-9P50
33-72011-9P50
C0.2
C0.3
C0.5
C0.2
C0.2
C0.3
C0.5
A.4 Standoff Types - Carrier Board
For different mounting procedures there are different standoffs available for the carrier board.
Note that threaded standoffs are both DIP and SMT type and the through-hole types are all SMT
type. Other types not listed can be made available upon request.
3 mm through-hole standoff (SMT type)
for HTS-EAT-B with 3 mm Hirose carrier
board connectors
3 mm threaded standoff (DIP type)
for HTS-EAT-BT with 3 mm Hirose carrier
board connectors
9.5 mm through-hole standoff (SMT type)
for HTS-EAT-B with 9.5 mm Hirose
carrier board connectors
9.5 mm threaded standoff (DIP type)
for HTS-EAT-BT with 9.5 mm Hirose
carrier board connectors