Instruction Manual

Chapter 4 BIOS Setup
ETX-PVR Reference Manual 51
 South Bridge Chipset Configuration
• Onboard LAN Controller [Enabled; Disabled]
- LAN Boot ROM [Enabled; Disabled]
- LAN Wake Up From S5 [Enabled; Disabled]
• HDA Controller [Enabled; Disabled]
• SMBus Controller [Enabled; Disabled]
• Video Function Configuration
 Initiate Graphic Adapter [PCI/IGD; IGD]
 Internal Graphics Mode Select [Enabled, 8MB]
 DVMT Mode Select [Fixed Mode; DVMT Mode]
• DVMT/Fixed Memory [128MB; 256MB; Maximum DVMT]
 Boot Display Device [CRT; LVDS; CRT + LVDS]
 Flat Panel Type [640x480; 800x600; 1024x768; 1280x800; 1366x768]
 Spread Spectrum Clock [Disabled; Enabled]
• IDE Configuration
 ATA/IDE Configuration [Disabled; Compatible; Enhanced]
• Legacy IDE Channels [SATA Only; SATA Pri, PATA Sec]
 Primary IDE Master [Not Detected]
 Primary IDE Slave [Not Detected]
 Secondary IDE Master [XGB NANDrive]
Device :Hard Disk
Vendor :XGB NANDrive
Size :X.0GB
LBA Mode :Supported
Block Mode :Not Supported
PIO Mode :X
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-6
S.M.A.R.T. :Supported
• Type [Not Installed; Auto; CD/DVD; ARMD]
• LBA/Large Mode [Disabled; Auto]
• Block (Multi-Sector Transfer) [Disabled; Auto]
•PIO Mode [Auto; 0; 1; 2; 3; 4]
• DMA Mode [Auto]
• S.M.A.R.T. [Auto; Disabled; Enabled]
• 32Bit Data Transfer [Disabled; Enabled]
 Secondary IDE Slave [Not Detected]
 Third IDE Master [Not Detected]
 Third IDE Slave [Not Detected]
 AHCI Settings