Manual

Table of Contents • iii
3.13 Offset Calibration .................................................................50
3.14 Offset Calibration to each Channel......................................51
3.15 Read Analog Data From Channel N ....................................52
3.16 Read All Analog Data Channel ............................................53
3.17 Enable/Disable channels for Multiplexing............................54
3.18 Read Channel Status...........................................................55
3.19 Read CJC Status .................................................................56
3.20 Enable/Disable CJC.............................................................57
3.21 Read enable/disable CJC Status.........................................58
3.22 Read Source High/Low Values for Linear Mapping.............59
3.23 Read Target High/Low Values for Linear Mapping..............60
3.24 Write Source High/Low Values for Linear Mapping.............61
3.25 Write Target High/Low Values for Linear Mapping..............62
3.26 Enable/Disable Linear Mapping...........................................63
3.27 Read enable/Disable Linear Mapping Status .....................64
3.28 CJC Offset Calibration .........................................................65
3.29 Clear Latched Alarm ............................................................66
3.30 Clear Event Counter ............................................................67
3.31 Disable Alarm.......................................................................68
3.32 Read Digital I/O and Alarm Status......................................69
3.33 Set Digital Output.................................................................71
3.34 Enable Alarm........................................................................72
3.35 Set High Alarm.....................................................................73
3.36 Set Low Alarm......................................................................74
3.37 Read Event Counter ............................................................75
3.38 Read High Alarm Limit .........................................................76
3.39 Read Low Alarm Limit..........................................................77
3.40 Read Leading Code Setting.................................................78
3.41 Change Leading Code Setting.............................................80
3.42 Set Host Watchdog Timer & Safety Value..........................82
3.43 Read Host Watchdog Timer & Safety Value.......................84
3.44 Host is OK ............................................................................85
Chapter 4 Data Format and Input Range ...................... 86
4.1 Data Format of Analog Input Modules .................................86
Engineering Units.......................................................................... 86
Percent of FSR (Full Scale Range) ............................................... 87
Two’s Complement Hexadecimal.................................................. 88
Ohm .............................................................................................. 89
4.2 Analog Input Range .............................................................90