Instruction Manual

58 • NuDAM-6521

X. bit 1 Don’t care, set to 0

X. bit 0 0 Don’t append <CR> in output string

1 Append <CR> in output string(*Default

Setting)

Y. bit 3 Don’t care, set to 0

Y. bit 2 Don’t care, set to 0

Y. bit 1 Don’t care, set to 0

Y. bit 0 0 Odd parity (*Default Setting)

1 Even parity

Z. bit 3 0 Non-parity mode (*DefaultSetting)

1 Parity mode

Z. bit 2 0 One stop bit (*Default Setting)

1 Two stop bit

Z. bit 1 0 00 5 data bit format

01 6 data bit format

10 7 data bit format

11 8 data bit format

@Response

!(Addr)<CR>

?(Addr)<CR>

(Addr) Address ID.

! Command is valid.

? Command is invalid. Invalid parameter values,

When you wanted to change the setting without

grounding the DEFAULT* pin.

Note :When you want to change the checksum or baud rate or

DataFlag, then the DEFAULT* pin should be grounded at

first.